Environmentally friendly wood mildew remover 1. Product introduction
The M mildew remover product produced by our company is a new generation of highly active mildew removal and mildew removal concentrate. The main ingredients of the product are mold decomposition factors, bactericidal and bacteriostatic agents. It removes mildew on products caused by a variety of bacteria, fungi, borers, and mold spores. It is the most effective, fastest, and most affordable new mildew removal product on the market.
The principle of product removal of mold is that the mold decomposition factor absorbs and captures the mold through the water-based carrier, pierces the mold cell membrane, fully penetrates into the interior to kill the mold, and decomposes the mold so that it falls off and disappears. For stubborn mildew that penetrates deeply into the product, Mold Remover can also achieve the effect of decomposing and inhibiting its regeneration. For products that are moldy due to various types of bacteria,
using Mold Remover can quickly decompose the mold while restoring the original color of the product material to the greatest extent,
leaving no traces of mold. This product is an environmentally friendly product for export. It is simple to operate. Just dilute it with tap water and soak the moldy products. For specific usage, please refer to the following product instructions.
Instructions for use
For products with slight mildew and only mildew spots and mildew spots on the surface, blending ratio: soak for about a minute or until the mildew spots disappear (tap water is enough).
B. For products with severe mildew, surface mold, or mold that has penetrated into the interior of the product, the blending ratio is: soaking, or spraying directly (tap water is enough)
Take: blending ratio as an example: put a bucket of cold water Pour it into the cement pool (cylinder), and then pour the mold remover into the bucket. After stirring thoroughly, put the moldy products into the potion and soak it. Make sure that the product does not come out of the water. Under normal circumstances, mild moldy products can be dealt with within minutes. After taking out the processed products, drip dry the potion and proceed to the next batch of processing immediately to avoid waste caused by volatilization of the potion.
It is recommended not to use more than 10 times of potion treatment each time, because as the number of treated products increases, the content of the mold removal factor decreases, and the efficacy of the potion will decrease accordingly, and the mold removal time will become longer, and even the decomposition of the mold will be ineffective. At this time, please add the potion as appropriate according to the actual situation to ensure the stability of the potion efficacy and processing time. If the liquid is turbid, it is recommended to reconstitute the liquid.
Note: If the product cannot be immersed in the liquid, it is recommended to use the original liquid or a liquid diluted twice, and spray it on the surface of the product several times to achieve the mold removal effect. The above ratios or suggestions are the test data of our company. The specific usage ratio should be tested in small quantities according to the actual products of the factory before batch processing to avoid waste.
Notes: This product is volatile. When not in use, store it in a sealed container at room temperature, in a cool, dry place. Avoid direct sunlight or high temperatures, and keep away from open flames to ensure product efficacy and stability.
Packaging instructions:/barrel is valid for 1 year.
wood mildew remover wood bleach